How to view the physical address of the computer (use command to view and network card to view)

How to view the physical address of the computer (use command to view and network card to view)

You can use this method to determine the correctness of your IP settings and obtain the physical address (MAC address) of the local network card, as follows:

1. Open "Start"-"Run"-enter 'cmd'-"OK" in the pop-up window

2. Enter ipconfig / all in the DOS window

As shown in the figure, the elliptical area, that is, Physical Address ....... is the physical address (MAC address) of the network card of the machine, and the rectangular area is the IP setting information of the machine.


The second method:
Right-click on "My Network Places" and select "Properties", the following window will appear.

Double-click the Internet protocol (TCP / IP), and you can see the IP address of the machine in the dialog box that appears. This method is also the most commonly used method.


Check the physical address, and place the mouse pointer at the position shown in the figure below, the network card physical address (MAC address) dialog box will appear.


Component Mounting And Soldering.The final step is to mount and solder the components. Both THT and SMT components are placed on the PCB by machines. THT components are most often soldered in an automated process called 'Wave Soldering'. This enables all components to be soldered simultaneously. Their legs are first cut near the board and slightly bent over to keep the component in place. The PCB is then moved over a wave of liquid flux, such that the bottom side strikes the flux. This removes any oxide from the metal surfaces. After heating the PCB it is similarly moved over a wave of melted solder. The solder attaches to the solder pads and component legs, and the soldering is complete.Component Mounting

Component Mounting

Component Mounting,Custom Component Mounting,Metal Component Mounting,Mount Bracket Component

Orilind Limited Company , https://www.orilind.com